NE555P

Texas Instruments
595-NE555P
NE555P

Fabricante:

Descripción:
Temporizadores y productos de apoyo Precision

Hoja de datos:
Modelo ECAD:
Descargue Library Loader gratis para convertir este archivo para su herramienta ECAD. Conozca más sobre el modelo ECAD.

En existencias: 28,624

Existencias:
28,624 Se puede enviar inmediatamente
Plazo de entrega de fábrica:
6 Semanas Tiempo estimado de producción de fábrica para cantidades superiores a las que se muestran.
Mínimo: 1   Múltiples: 1
Precio unitario:
S/-.--
Precio ext.:
S/-.--
Est. Tarifa:

Precio (PEN)

Cantidad Precio unitario
Precio ext.
S/1.95 S/1.95
S/1.40 S/14.00
S/1.25 S/31.25
S/1.09 S/109.00
S/1.00 S/250.00
S/0.958 S/479.00
S/0.919 S/919.00
S/0.872 S/3,488.00
S/0.837 S/6,696.00

Atributo del producto Valor de atributo Seleccionar atributo
Texas Instruments
Categoría de producto: Temporizadores y productos de apoyo
RoHS:  
Standard
1 Timer
TTL
PDIP-8
4.5 V
16 V
0 C
+ 70 C
NE555
Through Hole
Tube
Marca: Texas Instruments
País de ensamblaje: MX
País de difusión: US
País de origen: MX
Corriente de salida de nivel alto: 200 mA
Corriente de salida de nivel bajo: - 200 mA
Corriente de suministro operativa: 2 mA
Tipo de producto: Timers & Support Products
Cantidad de empaque de fábrica: 50
Subcategoría: Clock & Timer ICs
Peso de la unidad: 440.400 mg
Productos encontrados:
Para mostrar productos similares, seleccione al menos una casilla de verificación
Seleccione al menos una de las casillas de verificación anteriores para mostrar productos similares en esta categoría.
Atributos seleccionados: 0

Esta funcionalidad requiere que JavaScript esté habilitado.

CNHTS:
8542399000
CAHTS:
8542390000
USHTS:
8542390090
JPHTS:
8542390990
TARIC:
8542399000
MXHTS:
8542399999
ECCN:
EAR99

NE555 Single Precision Timers

Texas Instruments NE555 Single Precision Timers are precision timing circuits capable of producing accurate time delays or oscillation. In the time-delay or monostable mode, the timed interval is controlled by a single external resistor and capacitor network. In the astable mode, the frequency and duty cycle can be controlled independently with two external resistors and a single external capacitor. The threshold and trigger levels normally are two-thirds and one-third, respectively, of VCC. These levels can be altered by use of the control voltage terminal. When the trigger input falls below the trigger level, the flip-flop is set, and the output goes high. If the trigger input is above the trigger level and the threshold input is above the threshold level, the flip-flop is reset and the output is low. The reset (RESET) input can override all other inputs and can be used to initiate a new timing cycle.